TK Custom Moonclip Saver Tool
TK Custom Moonclip Saver Tool – S&W 6, 7 & 8 – Shot
TK Custom Moonclip Saver Tool. The best way to look after your moon clips.There are 3 parts to the Moon Clip Saver Tool.
The top part (TK Custom laser engraved on top) into which the centre press pin fits.
- Has small hole in the top of the body
The Base (Moon Saver Tool laser engraved on bottom) has a large hole in it.
- Beveled depression / machined circle where the Moonclip sits during straightening
The center press pin, which has two sides, fits into the top.
- B Starting Angle
- A Finishing Angle
| Manufacturer |
|---|
€ 193,06
1 in stock
TK Custom Moonclip Saver Tool
Moon Clip Saver Tool
S&W 6, 7 & 8 - Shot (User Instructions)
A Hard-flat surface is recommended to push against.
- Place the bent moon clip onto the beveled depression/machined circle in the base.
- Place the center press pin starting angle “B” facing out, into the top.
- Insert top assembly into the base holding the bent moon clip.
- Give several forceful presses down onto the moon clip, flip the moon clip over and repeat.
- Do this until one side of the moon clip (is cupped at this point) has all the outside edges resting evenly on a flat surface.
- Reverse the center press pin so finishing angle “A” is facing out, and reinsert into the top.
- Place the moon clip with the cupped side down into the beveled depression/machined circle of the base.
- Insert the top assembly into the base.
- Press down on the moon clip tool and gradually lighten the pressure until the moon clip is straight.
- A Hard-flat surface is recommended to push against.
- Check for straightness/flatness on the flat bottom of the base.
- Repeat the steps if necessary, until moon clip is straight and flat.
Additional information
| Manufacturer |
|---|
